This project is read-only.

Socket Type H

A USB host interface that allows USB peripherals to connect to the mainboard. Pins 4 and 5 are used as the dedicated USB data pins (D- and D+). In addition, pins 3 is a general-purpose input/output with interrupt capabilities.

Pinout

Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 Pin 9 Pin 10
+3.3V +5V GPIO! D- D+ [UN] [UN] [UN] [UN] GND


Legend:

GPIO

A general-purpose digital input/output pin, operating at 3.3 Volts.

! Interrupt-capable and software pull-up capable GPIO (the pull-up is switchable and in the range of 10,000 to 100,000 ohms).

[UN]

Modules must not connect to this pin if using this socket type. Mainboards can support multiple socket types on one socket, as long as individual pin functionalities overlap in a compatible manner, so that a pin from one socket type can overlap with a [UN] pin of another.

+3.3V Connection to the +3.3V power net.
+5V Connection to the +5V power net.
GND Connection the power ground net.

Connector Pin Numbering

Pins numbers for the male 10-pin connector standard Gadgeteer socket, as seen from above. In most cases, the ribbon cables will have the pin 1 conductor marked in red.

ConnectorPinNumbering_thumb

Last edited Nov 10, 2011 at 3:38 PM by nvillar, version 2

Comments

No comments yet.